ATE Products

Overview

cRIO-M1553 interface module for the National Instruments CompactRIO™ embedded systems and R Series expansion chassis provide high-performance simulation for a wide variety of industrial, in-vehicle and laboratory MIL-STD-1553 interfaces. Each module can operate in one of the following modes: Bus Controller (BC), Remote Terminal (RT), Bus Monitor (BM). In RT mode it is possible to simulate up to 4 remote devices.

Overview

cRIO-A429-4Rx signal input module for the National Instruments CompactRIO™ embedded systems and R Series expansion chassis provide high-performance measurements and simulation for a wide variety of industrial, in-vehicle and laboratory ARINC-429 interfaces. Each module provides built-in signal processing.

Overview

cRIO-A429-4Tx signal output module for the National Instruments Compact RIO™ embedded systems and R Series expansion chassis provide high-performance simulation for a wide variety of industrial, in-vehicle and laboratory ARINC-429 interfaces. Each module provides built-in transmitting memory buffer for independent operation.

Lifting device parameter recorder during ore and placer deposits development by means of underground method

Recorder functions

• Data acquisition of lifting device terminal switches
• Motor currents measurement
• Tonnage of ore in skip measurement

Airborne illumination systems test
Operation in laboratory and environmental conditions

FOTON-2004

• Brightness measurement range 0,1 – 2000 cd/m2
• Lighting measurement range 0,3 – 6000 cd
• Spectral range of input emission 400 – 700 Nm

Roll products parameter control

Principal functions

• Geometrical dimensioning of square and circular section bars
• Form of section error calculation
• Data transfer to upper level

Data acquisition and processing during on-board system test

Airborne recorder-01 (БН-01)operation modes

• Start of information record mode
• Stop of information record mode
• Memory clearing

Communication channels system

Standards

• GSM\EDGE
• WLAN 802.11
• FSK, BFSK
• ASK

Laboratory computer-aided test stand

Principal functions

• Simultaneous test of 180 tensotransformers for several minutes
• Cold junction consideration
• Floating zero compensation